Installation of Dial-Up Networking

There a several methods to install "Dial-Up Networking", I prefer to do is as "Network" installation, so I select in the "Control-Panel" the "Network"-applet and if there was previously no network-component installed:
(if there is already a network installed, select the tab:"Services", then the "Add" button and select "Remote Access Services"):

	No network was previously installed, but since Dial-Up Networking is a Network, we will continue with the NT Networking installation.
	Assuming, that you have only the modem to install (and NOT a real network-board in addition), please put a Check-Mark only at "Remote Access to Network", then select "Next"
	One more confirmation screen.
	If your modem was already configured, it will be selected as "RAS Capable Device", select "OK"
	We need now to configure the modem: Select "Network" and define, which protocols you intend to use for Dialing out. Since I plan to connect to the Internet, I need "TCP/IP". Since I also intend to dialin to the office network with Netware Servers, I also need to define "IPX" protocol.
	We need also to define/ check the "Configure": by default, it is setup for "Dial out only". For now, we leave it like that , select "OK"
	That's it. Since a serious change to the network setup has been installed, we are requested to reboot.

After the reboot, I suggest to have a look at the new Network-setup:

Verification of the Dial-Up Networking Setup